20% Off for Military and Medical Providers
How to install the linkage on the front axle of LDRC LD18401 RC car?
First, take out LDRC LD18401 tie rod you purchased, and select only the two shortest ones with half-round from the eight tie rod. (these two front drive shafts that I circle)
Take out the shock double-ended screws, and use a tool to clamp the LDRC LD18401 shock ball end and the screw tightly. (The ball end and the semicircular part of LDRC LD18401 tie rod should be on the same side; be careful not to install them backwards.)
Next, tighten the ball end screw onto ldrc ld18401 tie rod. When tightening the screw, be sure to hold the screw and the tool firmly with your hand to prevent the screw from falling during installation.
This completes the installation of the tie rod for the LDRC LD18401.
The stock linkage is made of plastic, so I recommend upgrading to a reinforced front axle assembly.
SHARE
Leave a comment
Related post
YoukeDou
Youkedou Store specializes in selling remote-controlled toys and offers a wide range of repair parts and modification options. We strive to become a unique RC model store.
xinxuntoys@foxmail.com
SHOP
MORE INFO
POLICY
