How to install the linkage on the rear axle of LDRC LD18401 RC car?

How to install the connect rod on the rear axle of LDRC LD18401 RC car?

First, take out the linkages you purchased. LDRC LD18401 rc car two linkages are the longest ones among the eight linkages.

 

 

Next, use a tool to clamp ldrc ld18401 shock double ball ends of the LDRC LD18401 mini rc car into the circular rings of the linkages.

 

 

Align ld18401 rc car linkage with the holes on the rear axle, then use a hex wrench to align with the shock screw and tighten the screw into the rear axle hole. (Hold the shock screw firmly while tightening to prevent it from spinning along with the hex wrench.)

 

 

Finally, you're all done! The linkages for the LDRC LD18401 rc climbing car are installed successfully.

 

 

The stock linkage is made of plastic, so I recommend upgrading to a reinforced front axle assembly.

Buy: LDRC LD18401 Upgrade Parts Tie Rod