MJX Hyper Go H10G Pre-Run Check List for Your New RC

Just got your brand-new MJX Hyper Go H10G? Don’t hit the throttle right away! Many new RC drivers crash or strip gears simply because they skip these easy pre-run checks.

Save this quick checklist for your MJX Hyper Go H10G — it will help you prevent plenty of broken parts!

1. Check all screws and wheel nuts on the MJX Hyper Go H10G and make sure nothing is loose. Tighten them all before your first run. Note that the thread locker on factory screws may not be fully cured. We recommend rechecking fasteners after a few runs.
2. Inspect your tires: look for cracks and confirm the tires are securely glued to the rims.
3. Test the suspension: check if the MJX H10G shocks move smoothly, with proper rebound and no binding.
4. Check the steering system: the servo should operate smoothly. Turn the steering on the stand and listen for strange noises, make sure the linkage is not jammed.
5. Battery and connectors: fully charge your battery, push the plug in firmly, and ensure the battery does not shift inside the chassis.

Finished the above checks? Time to power up and test your MJX Hyper Go H10G! Do you know the correct startup order? Always turn on the transmitter first, then the RC car, to prevent runaway. Next, adjust your throttle and steering trim, and verify the steering direction is correct. Do a quick range test before driving at full speed.

Once you finish all these checks, you can enjoy your MJX Hyper Go H10G safely! Has anyone already picked up the MJX Hyper Go H10G? Leave a comment down below.

If you want to buy this MJX Hyper Go H10G 1/10 RC Crawler, click the link below: MJX Hyper Go H10G.